SC732 Chassis Manual
4-8
Figure 4-7. Installing 2.5" Hard Drives
5. If a hard drive is already present, remove it by carefully pulling the sides of
the hard drive carrier outward.
6. Remove the hard drive from the hard drive carrier.
7. Insert the new hard drive into the hard drive carrier.
8. Insert the hard drive carrier into the hard drive cage, sliding it towards the
back of the the hard drive cage until it clicks into a locked position.
9. Slide the 2.5" hard drive cage back into the chassis and tighten the thumb
screw to secure the cage.
10. Connect the related cables to the hard drive.
11. Plug the power cord back into the power module, replace the chassis cover
and power-up the system.
Warning: Only enterprise level HDDs are recommended for use in this chassis.
1
8
1
9
