4-17
Chapter 4: Chassis Setup and Maintenance
The SC732 chassis includes either a 500W, redundant 500W, 865W or 900W power
supply. In the unlikely event that it becomes necessary to replace the power supply,
follow the instructions below.
4-11 Power Supply
Changing the Power Supply
1. Power down the system and remove the power cord from the rear of the
power supply. Remove the chassis side cover as described in Section 4-2.
2. Disconnect the motherboard cables.
3. Remove the screws securing the power supply to the chassis. Set these
screws aside for later use.
4. Gently lift the power supply out of the chassis.
5. Replace the failed power supply with an identical power supply model.
6. Secure the new power supply using the screws previously set aside.
7. Plug the power cord back into the power module and power-up the system.
Figure 4-16. Removing the Power Supply
Power Supply
