101
Appendix D: M35T1 Mobile Rack Specifications
D.13 Preparation for Installation
Tools Required
The following tools are required to install the mobile rack into the chassis:
•
Phillips head screwdriver
•
Antistatic strap (recommended)
Important Safety Guidelines
This product should be assembled and/or serviced by qualified and experienced technicians.
To avoid personal injury and property damage, carefully follow the guidelines listed below.
Safety Guidelines
1. Power down the system, unplug the power cords from the rear of the power supplies
and open the chassis cover.
2.
When disconnecting cables, label them for easy identification.
3. Use a grounded wrist strap designed to prevent static discharge when handling
components.
4.
Save all the screws and fasteners for later use and label them for easy identification.)
5. Follow the installation procedures in the following section of this manual to remove and
install the hard drives, cooling fan, and the back panel of the mobile rack.
Warning! Enterprise level hard disk drives are recommended for use in Supermicro chassis
and servers. For information on recommended HDDs, visit the Supermicro website at