SC825 Chassis Manual
5-8
Installing the Rear 2.5" Hard Drive Cage (CSE-825B Only)
The CSE-825B model chassis supports an optional hard drive cage for two
additional 2.5" hot-swappable hard drives. The hard drive cage installs in the rear of
the chassis next to the power supply. Once the hard drive cage has been installed,
the 2.5" hard drives may be removed without powering down the server.
Installing the 2.5" Rear Hard Drive Cage
1.
Power down as described in section 5-3, lay the chassis on a flat, stable
surface and remove the chassis cover.
2.
Remove the three screws connecting the bezel and lift the bezel off.
3.
Remove the two standoffs.
Figure 5-8. Installing the Rear 2.5" Hard Drive Cage
1
2
1
3
Note:
Keep these two removable standoffs after installing the rear hard drive cage.
If you want to remove the rear hard drive cage in the future, these two removable
standoffs will need to be placed back to the chassis to ensure there are no opening
holes on the chassis base.