5-7
Chapter 5: Chassis Setup and Maintenance
5-6 Installing an Optional Fixed Hard Drive
The SC825 chassis models include two open slots for optional hard disk drives. To
utilize these slots, the dummy drive and the slot cover must be removed.
Removing the Dummy Drive or Hard Disk Drive
1. Power down the system and remove the power cords from the rear of the
power supply. Open the chassis cover as described in Section 5-3.
2. Press the release tab.
3. Push against the back of the dummy drive, sliding the dummy drive and slot
cover forward, out through the front of the chassis.
4. Insert the drive into rear of the open slot and connect the wiring.
1
3
1
2
Figure 5-7. Removing the Dummy Drive and Slot Cover
Release Tabs