SC825M Chassis Manual
5-12
5. For a
full-height
extension card, release the clamp that secures all four PCI
shields. Looking at the rear of the chassis, this clamp is in the right corner.
Unscrew the single screw that secures the clamp and rotate the clamp away
from the shields.
For a
low profile
extension card, release the box-shaped clamp that secures
all three PCI shields. Looking at the rear of the chassis, this clamp is near the
middle, just left of the low profile PCI slots. Unscrew the single screw that se
-
cures the clamp and slide the clamp to the left away from the shields.
6. Insert the expansion card into a slot on the riser card while aligning the expan-
sion card backplate with the open slot in the rear of the chassis. Repeat for
other expansion cards if you are installing more than one.
7. Secure the card backplates to the chassis by returning the clamp to the closed
position and installing the locking screw.
8. Replace the chassis cover and power up.
Note
: This U model chassis is
pictured without the riser card
bracket.
Full-Height Card
Shield Clamp
Low Profile Card
Shield Clamp
Figure 5-13. Remove an Expansion Card Slot Shield
