5-16
SC842 Chassis Manual
1
3
Installing the DVD-ROM and Peripheral Drive
SC842 chassis models supports a slim DVD-ROM and up to three 5-1/4" peripheral
drives.
Figure 5-14. Installing the Peripheral Drive
Installing a Peripheral Drive
1. Power down the system and remove the power cord from the rear of the
power supply. Remove the cords from both power supplies if your chassis
includes a redundant power module. Remove the chassis cover as described
in Section 5-2.
2.
If adding a drive to the chassis, r
emove the mini-bezel from the drive bay
The mini-bezel is the small grating that covers the drive bay. Remove this by
simply pulling it out of the bay.
If replacing an existing drive, r
emove the existing drive by depressing the
release tab, then pulling the drive out of the chassis.
3. Attach the two guide screws which are included in the accessory box.
4.
Insert the new drive unit in the slot until the release tab locks into place.
5. Connect the data and power cables to the motherboard.
6. Reconnect the power cord(s) to the power supply (and the redundant power
supply if applicable to your chassis model), and power up the system.
Release Tab
Guide Screws
