5-2
SC842 Chassis Manual
5-2 Removing the Chassis Cover
Removing the Chassis Cover
1. Power down the system and remove the power cord from the rear of the
power supply. Remove the cords from both power supplies if your chassis
includes a redundant power module.
2. Remove the screw at the rear of the chassis and set it aside for later use.
3. Remove the two screws on the sides of the cover and set them aside.
4. Lift the cover up and off the chassis.
Figure 5-1. Removing the Chassis Cover
Warning: Except for short periods of time, do NOT operate the chassis without
the cover in place. The chassis cover must be in place to allow proper airflow and
prevent overheating.
4
3
1
3
2
