SC846X Chassis Manual
4-8
To install drives in the rear drive drawer, first remove the drawer from the rear of
the chassis.
Removing the Rear Drive Drawer
1. Power down the system as described in Section 5-2 and remove the chassis
cover.
2. If any drives are already installed, disconnect the existing power and data cables
from the serverboard and the power distributor board. Otherwise the cables will
prevent the drawer from sliding all the way out.
3. Identify the drive drawer release button. It is on the inside left wall of the chassis
under the chassis shelf the holds the serverboard and fans. See the diagram
below.
4. Reach into the chassis in front of the fans, and pull the release button while
pushing the drawer toward the rear the chassis.
5. From the rear of the chassis, pull the drawer out.
Figure 4-8. Drive Drawer Release Latch
Release Button on
Inside of Drawer Wall
Release
Button
Position of Release Button
When Drawer is Closed
(inside chassis)
Summary of Contents for SC846X
