SC848 Chassis Manual
4-20
Replace the power distributor board cover by routing three pairs of 4-pin
11.
backplane connector cables out the front of the power distributor board cover.
Route the 24-pin connector cable and the two 8-pin motherboard connector
cables out the top of the power distributor board cover and leave the 4-pin
connector aside for peripheral use.
Reconnect all the power cables. Spread the power cables to the motherboard
12.
carefully before replacing the middle bracket. Make sure the wires passing
through the rubber gates of the bracket are not being squeezed.
Replace the power supplies, and insert the plug into the wall.
13.
Figure 4-24: Routing Cables from the Power Distributor Board
Summary of Contents for SC848A-R1800B
