SC848 Chassis Manual
4-28
4-11 Accessing the Backplane
The SC848 chassis backplane is located behind the hard drives and in front of the
front system fans. In order to change jumper settings on the backplane, it may be
necessary to remove the backplane from the chassis.
Removing the Backplane
Power down and unplug the system from any power source.
1.
Pull all of the existing hot-swappable hard drives half-way out of their drive
2.
bays in the front of the chassis.
Disconnect the cabling to the backplane.
3.
Remove the four upper screws securing backplane housing to the chassis
4.
and set these aside for later use.
1
4
Figure 4-37: Removing the Four Upper Screws
Remove Four
Upper Screws
Summary of Contents for SC848A-R1800B
