SBI-6419P-C3N SuperBlade Module User’s Manual
4-8
Hard Disk Drives
The SBI-6419P-C3N blade unit accommodates up to three 2.5" SATA/SSD/NVMe hard
disk drives, which are mounted in drive “trays”. The drives can be hot-swapped and
removed or replaced without powering down the blade unit they reside in. The three
drives can be used to set up a RAID 0, 1, 5 or 10 array. These drives use a blue color for
the Blade HDD active LED. See
for information on RAID Setup.
Additional drives can be added by a module card mounted in the front.
For RAID setup see
http://www.supermicro.com/support/manuals/
under RAID
Installation Guides for details.
Caution:
To maintain proper airflow, both hard drive bays must have drive carriers inserted
during operation whether or not a drive is installed in the tray.
Enterprise level hard disk drives are recommended for use in Supermicro
chassis and servers. For information on recommended HDDs, visit the Supermicro website
at
http://www.supermicro.com/products/nfo/storage.cfm
Summary of Contents for SuperBlade SBI-6419P-C3N
