27
Chapter 3: Installation and Setup
3.5 Removing and Replacing the Blade Cover
The blade cover can be removed to access the mainboard and install processors, memory
modules, the onboard battery, etc.
•
To remove the cover, remove the screw as illustrated below. Slide the cover toward the
rear and lift it off.
•
To replace the cover, fit the six studs on the inside of the cover into the slots of the chas-
sis, then slide the cover toward the front of the blade to lock it into place. Replace the
locking screw.
Figure 3-2. Removing the Cover
Screw
Studs
Slots
