SuperBlade User’s Manual
3-4
Installation
Use the procedure below for installing an enclosure in a rack.
Installing an enclosure:
1.
Decide where you want to place the blade enclosure into the rack (see
"Rack
Mounting Considerations"
in the previous section).
2.
Position the Enclosure Template at the front of the enclosure to determine the
locations of the screws for the enclosure rails (see
Figure 3-1
).
Figure 3-1. Positioning the Enclosure Template
3.
The two enclosure rail sections are screwed together to keep them immobile during
shipping. Release these screws just enough to allow the rails to slide apart. Note the
arrow on the rail, which indicates the end that attaches to the front of the rack.
4.
Slide the rails apart far enough to match the depth of the rack. Position the rails with
the template and secure the front of each to the front of the rack with two flathead
screws, then secure the back of each rail to the rear of the rack with two flathead
screws (see
Figure 3-2
). Note that the rails are left/right specific and very heavy.
Figure 3-2. Securing the Rails to the Rack
5.
(Optional step) Add the front left and right handles to the enclosure using five
screws to secure each handle. Install a thumbscrew through the bottom hole of
each handle (see
Figure 3-3
).
Summary of Contents for SuperBlade Series
