3-3
Chapter 3 System Interface
N I C 1 :
I n d i c a t e s n e t w o r k a c t i v i t y o n G L A N 1 w h e n f l a s h i n g .
N I C 2 :
I n d i c a t e s n e t w o r k a c t i v i t y o n G L A N 2 w h e n f l a s h i n g .
Overheat/Fan Fail:
When this LED flashes it indicates a fan failure. When continu
-
ously on (not flashing) it indicates an overheat condition, which may be caused by
cables obstructing the airflow in the system or the ambient room temperature being
too warm. Check the routing of the cables and make sure all fans are present and
operating normally. You should also check to make sure that the chassis covers
are installed. Finally, verify that the heatsinks are installed properly. This LED will
remain flashing or on as long as the overheat condition exists.
Power Failure:
When this LED flashes, it indicates a failure in the redundant power
supply.
!
Summary of Contents for Supero SC936 Series
Page 18: ...SC936 Chassis Manual 3 4 Notes ...
Page 30: ...SC936 Chassis Manual 4 12 Notes ...
Page 40: ...SC936 Chassis Manual 5 10 Notes ...