Chapter 2: Server Installation
2-7
Figure 2-4. Installing the Server into a Rack
Installing the Server into the Rack
You should now have rails attached to both the chassis and the rack unit. The next
step is to install the server into the rack.
Installing to Rack
There are two brackets in the rack mount kit. Install these fi rst keeping in
mind that they are left/right specifi c (marked with "L" and "R").
Line up the rear of the chassis rails with the front of the rack rails. Slide the
chassis rails into the rack rails, keeping the pressure even on both sides (you
may have to depress the locking tabs when inserting).
When the server has been pushed completely into the rack, you should hear
the locking tabs "click".
Finish by inserting and tightening the thumbscrews that hold the front of the
server to the rack (see Figure 2-4).
1.
2.
3.
4.
Summary of Contents for SUPERSERVER 8045C-3R
