26
X10SRM-F/-TF User Manual
2.3 Processor and Heatsink Installation
Warning:
When handling the processor package, avoid placing direct pressure on the label
area of the fan.
Important:
•
Always connect the power cord last, and always remove it before adding, removing or
changing any hardware components. Make sure that you install the processor into the
CPU socket before you install the CPU heatsink.
•
If you buy a CPU separately, make sure that you use an Intel-certified multi-directional
heatsink only.
•
Make sure to install the motherboard into the chassis before you install the CPU heatsink.
•
When receiving a motherboard without a processor pre-installed, make sure that the plastic
CPU socket cap is in place and none of the socket pins are bent; otherwise, contact your
retailer immediately.
•
Refer to the Supermicro website for updates on CPU support.
Installing the LGA2011 Processor
1.
There are two load levers on the LGA2011 socket. To open the socket cover, first press
and release the load lever labeled 'Open 1st'.
Press down
on Load Lever
labeled 'Open 1st'.
OPEN 1s
t
OPEN 1s
t
1
2
Note:
All graphics, drawings and pictures shown in this manual are for illustration only.
The components that came with your machine may or may not look exactly the same
as those shown in this manual.
Summary of Contents for X10SRM-F
