3-2
S
UPER
S
ERVER 1027R-73DARF User's Manual
3-3 Control Panel LEDs
The control panel located on the front of the SC113TQ chassis has five LEDs. These
LEDs provide you with critical information related to different parts of the system.
This section explains what each LED indicates when illuminated and any corrective
action you may need to take.
Note:
deactivating the UID LED must be performed in the same way it was activated.
(If the UID LED was activated via IPMI, you can only turn the LED off via IPMI and
not with the UID button.)
Information LED
This LED will be solid blue when the UID function has been activated. When this
LED flashes red, it indicates a fan failure. When red continuously it indicates an
overheat condition, which may be caused by cables obstructing the airflow in the
system or the ambient room temperature being too warm. Check the routing of
the cables and make sure all fans are present and operating normally. You should
also check to make sure that the chassis covers are installed. Finally, verify that
the heatsinks are installed properly (see Chapter 5). This LED will remain flashing
or on as long as the indicated condition exists.
Information LED States
State Indication
Continuously On (Red)
An overheat condition has occured.
Fast Blinking Red (1 Hz)
Fan Failure
Slow Blinking Red (.25 Hz)
Power Fail
Solid Blue
Local UID button has been activated.
Blinking Blue
IPM/Remote UID has been activated
Summary of Contents for 1027R-73DARF
