2-8
S
UPER
S
ERVER 6026T-NTR+ User's Manual
2-5 Checking the Serverboard Setup
After you install the 6026T-NTR+ in the rack, you will need to open the unit to
make sure the serverboard is properly installed and all the connections have been
made.
Accessing the inside of the System
First, grasp the two handles on either side and pull the unit straight out until it
1.
locks (you will hear a "click").
Next, depress the two buttons on the top of the chassis to release the top
2.
cover.
You can then lift the top cover from the chassis to gain full access to the
3.
inside of the server.
Checking the Components and Setup
You may have one or two processors already installed into the serverboard.
1.
Each processor needs its own heat sink. See Chapter 5 for instructions on
processor and heat sink installation.
Your 6026T-NTR+ server system may have come with system memory al-
2.
ready installed. Make sure all DIMMs are fully seated in their slots. For details
on adding system memory, refer to Chapter 5.
If desired, you can install add-on cards to the system. See Chapter 5 for
3.
details on installing PCI add-on cards.
Make sure all power and data cables are properly connected and not blocking
4.
the chassis airfl ow. Also make sure that no cables are positioned in front of
the fans. See Chapter 5 for details on cable connections.
Summary of Contents for 6026T-NTR+
