4-8
H8DSR-8/H8DSR-i User's Manual
MCT Timing Mode
Sets the timing mode for memory. Options are
Auto
and Manual.
User Confi guration Mode
Options are
Auto
and Manual.
Bank Interleaving
This setting is used to determine whether bank interleaving is to be employed.
The options are
Auto
and Disabled.
Burst Length
Use this setting to set the memory burst length. 64-bit Dq must use 4 beats.
Options are 8 beats,
4 beats
and 2 beats.
Enable Clock to All DIMMs
This setting allows the user to enable unused clocks to DIMMs, even if DIMM
slots are empty. Options are Enabled and
Disabled
.
Hardware Memory Hole
When "Enabled", allows software memory remapping around the memory hole
(only supported by rev. E0 processors and above). Options are Enabled and
Disabled
.
Node Interleaving
Use this setting to Enable or
Disable
node interleaving.
ECC Confi guration
DRAM ECC Enable
DRAM ECC allows hardware to report and correct memory errors automati-
cally. Options are
Enabled
and Disabled.
MCA DRAM ECC Logging
When "Enabled", MCA DRAM ECC logging and reporting is enabled.
Options are Enabled and
Disabled
.
