5-7
Chapter 5: Chassis Setup and Maintenance
5-6 DVD-ROM Replacement or Installation
Most SC825 chassis models include a DVD-ROM which is usually pre-installed.
Installing or Replacing a DVD-ROM Drive
Power down the system and if necessary, remove the server from the rack.
1.
Remove the chassis cover.
2.
Unplug the drives power and data cables from the motherboard and/or back-
3.
plane.
If you are adding a new DVD-ROM drive:
4.
Remove the mini-bezel (grate)
from the drive bay The bezel can be removed by pulling out the hard drive
beneath the DVD-ROM drive bay, then pulling the mini-bezel forward.
If you are replacing a drive:
Locate the locking tab at the rear (left hand
side when viewed from the front) of the DVD-ROM drive. Push the tab toward
the drive and push the drive unit out the front of the chassis.
Insert the new drive unit in the slot until the tab locks in place.
5.
Reconnect the data and power cables.
6.
Replace the chassis cover (replace the server in the rack, if necessary) and
7.
power up the system.
Replacing the DVD-ROM and Front Panel
SC825 chassis models include a slim DVD-ROM, and front port panel. Use the
instructions in this section in the unlikely event that you must replace any of these
components.
Figure 5-8: Install the DVD-ROM and Front Panel
Front Port Panel
DVD-ROM
