D-7
Appendix D: BPN-SAS2-847EL Backplane Specifications
General Jumper Settings
Jumper
Jumper Settings
Note
PRI_MODE1 and 2
Pins 2-3
Factory Setting
Do not change
SEC_MODE1 and 2
Pins 2-3
Factory Setting
Do not change
MDI01 and 02
No jumper required
SMC internal use only
UART_P1
No jumper required
Primary UART connector
UART_S1
No jumper required
Secondary UART connector
(Not present on BPN-SAS2-
847E2)
JP1
No jumper required
Buzzer connector
BUZZER_ENB1
Open: Disable
Closed: Enable
Buzzer enable*
ACTLED1
Open: Disable
Closed: Enable
For manufacturing use only
FAN_MONITOR_DIS-
ABLE
Open: Enable
Closed: Disable
Fan monitor settings
FANFAIL_LED_DIS-
ABLE
Open: Enable
Closed: Disable
Disables the fan failure LED
EXPDBG1
N/A
For manufacturing use only.
EXPDBG2
N/A
For manufacturing use only.
*The buzzer sound indicates that a condition requiring immediate attention has
occurred.
The buzzer alarm is triggered by the following conditions:
1. Hard drive failure
2. Fan failure
3. System temperature over 45º Celsius.
Summary of Contents for SC847E16-R1K28JBOD
