Chapter 2: Server Installation
2-13
Figure 5-1: Removing the Chassis Cover
Remove Screws
1
4
1
3
1
2
1
3
Checking the Components and Setup
1. You may have one or two processors already installed into the serverboard.
Each processor needs its own heat sink. See Chapter 5 for instructions on
processor and heat sink installation.
2. Your 8047R-TRF+/7RFT+ server system may have come with system
memory already installed. Make sure all DIMMs are fully seated in their slots.
For details on adding system memory, refer to Chapter 5.
3. If desired, you can install add-on cards to the system. See Chapter 5 for
details on installing PCI add-on cards.
4. Make sure all power and data cables are properly connected and not blocking
the chassis air
fl
ow. Also make sure that no cables are positioned in front of
the fans. See Chapter 5 for details on cable connections.
