4-6
X6DVL-G/X6DVL-EG
User’s Manual
P-ATA Channel Selection
This feature allows the user to select which channel to set the
Parallel ATA Mode. The options are: Primary, Secondary or
Both.
S-ATA Ports Definition
This feature allows the user to configure Serial ATA Ports. The
options are:
P0-3rd/P1-4th
, P0-4th/P1-3rd
.
Configuring S-ATA as RAID
Select Yes to configure Serial ATA as RAID. The options are Yes,
and
No
.
S-ATA Only
S-ATA Ports Definition
This feature allows the user to configure Serial ATA Ports. The
options are:
P0-1st/P1-2nd
, P0-2nd/P1-1st
.
Primary IDE Master/Slave, Secondary IDE Master/Slave, Third
IDE Master/Slave, Fourth IDE Master/Slave Sub Menu
From the Advanced Setup screen, press <Enter> to access this sub menu
for the primary, secondary, third and fourth IDE master and slave drives.
Use this screen to select options for the Primary and Secondary IDE drives.
Use the up and down <Arrow> keys to select an item. Use the <Plus> and
<Minus> keys to change the value of the selected option.
Type
Select the type of device connected to the system. The options are Not
Installed,
Auto
, CDROM and ARMD.
LBA/Large Mode
LBA (Logical Block Addressing) is a method of addressing data on a disk
drive. In the LBA mode, the maximum drive capacity is 137 GB. For drive
capacities over 137 GB, your system must be equipped with 48-bit LBA
mode addressing. If not, contact your manufacturer or install an ATA/133
IDE controller card that supports 48-bit LBA mode. The options are Dis-
abled or
Auto
.
Block (Multi-Sector Transfer)
Block mode boosts IDE drive performance by increasing the amount of
data transferred. Only 512 bytes of data can be transferred per interrupt
if block mode is not used. Block mode allows transfers of up to 64 KB
per interrupt. Select Disabled to allow the data to be transferred from
and to the device one sector at a time. Select Auto to allows the data
transfer from and to the device occur multiple sectors at a time if the
device supports it. The options are
Auto
and Disabled.
