Installation Instructions - #SS401/SS500
Rear Trac Bar
Installation of the Frame Bracket B-754 and Pinch Plate B-753
Install the frame bracket B-754 and pinch plate B-753 on the frame rail. The frame must be between the
pinch plate and the frame bracket. The frame bracket is designed to mount to the bottom and sides of
the frame rail. Position the frame bracket below the frame rail on the passenger side in line with the axle
bracket.
Align slotted holes in frame bracket with threaded holes in pinch plate. (Place the nut plate with lip facing
down and towards center of vehicle). Install (2) 5/8”x2” fine threaded bolts, (2) 5/8” lock washers & (2)
5/8” flat washers. (Use blue Loctite and tighten “just snug” for now)
Note:
Make sure not to contact any wires, brake lines, etc. This kit also includes zip
ties and flexible plastic conduit should coach wiring needs to be moved or shielded.
Use the Trac Bar to check alignment from differential plate to frame bracket. Adjust forward or back. Then
install the jam nuts onto the ½” fine threaded bolts and install in the frame bracket. Tighten to push the
nut plate against the inside of the frame, then tighten the bottom bolts securely. Now tighten the jam nuts
against the bracket to lock the ½” fine threaded bolts into place and keep it from backing out.
Installation of Rod Assembly (SS401-1)
Note:
The rod assembly may be installed on the front or back of the brackets to
achieve best clearance.
Install the rod assembly with the ¾” x 3” bolts, flat washers and lock-nuts. Be sure that there is a flat
washer on both sides of the urethane bushings of the rod end. When adjusting the length of the rod, it is
necessary that the coach’s full weight be on the suspension.
Torque all the standard ½” bolts on the Differential Bracket to 120 ft. lbs. If a Dana 110, 130, or 150 mod
-
el with metric bolts, torque to 142 - 158 ft. lbs. Be sure to check all fasteners for tightness, including the
jam nut on the rod assembly. Torque the ¾” rod end bolt to 150 – 180 ft. lbs. Torque the jam nut to 100 -
150 ft. lbs. This completes the installation.
Test drive.
To register your product for warranty purposes, go to the SuperSteer website at
www.SuperSteerParts.com
and fill out the online registration card
Re-check torque in 6 months.
