5: Installation of front wheels and wheel covers:
Locate the 2 wheels that do not have the hub attached to them.
(Wheels will be flat on both sides) Insert the small black plastic
bushings into the center hole on the back side of the wheel. Install a
flat washer onto each of the front axles. Slide one wheel onto the
front axle on each side of the car. While sliding the wheel onto the
axle, press the center button of the wheel and slide wheel on
completely and let go of center button. Pull gently on the wheel to
make sure that wheel is locked into place.
6: Installation of the rear wheels and wheel covers:
The remaining 2 wheels will have a hub on the back side of the
wheel. Insert small black plastic bushings into the center hole on the
back side of the wheel. Slide one wheel onto the rear axle on each
side of the car. You will need to line up the hub with the motor on
the axle. While sliding the wheel onto the axle, press the center
button of the wheel and slide wheel on completely and let go of
center button. Pull gently on the wheel to make sure that wheel is
locked into place.
