PARTS LIST
#
Name
Qty
#
Name
Qty
1
Seat
1
6
Side Mirrors
2
2
Steering Wheel
1
7
Remote
1
3
Wheels
4
8
Charger
1
4
Windshield
1
9
Wheel Nut Wrench
2
5
Under carriage
bracket
1
10
Bag of Hardware
1
All assembly videos can be found on
YouTube under SPORTrax
1: Installation of the rear wheels:
Disconnect the 2 rear wheel motors from the vehicle. Make sure to
take note which is the right motor and which is the left motor. (If
the motors are not installed on the correct side of the car as when
removed, it will affect whether the car moves in the correct
direction when selecting forward or reverse.) Turn the car
upside down, and slide the previously disconnected motors onto
the left and right ends of the rear axle. Feed the wires through the
body of the car, and reconnect to the motor wiring. Once motors
are reconnected place a hub adaptor on each side of the axle. Insert
wheel bushing into front and back of wheel. Slide wheel on the
axle while aligning the grooves of the hub adaptor to the backside
of the wheel. Place metal washer and nut on the axle. Tighten the
nut with supplied lug nut wrenches until snug. Do not over. Place
center cap over nut and snap into place. Check the reverse/forward
mode of the car to make sure the wheels are turning in the right
direction. If not switch the motor wires and check again. Make sure
you do this step before installing the seat.
