Remote Control Function
Remote Control Instructions:
For the first time use of remote control
or after replacing the battery, you need to sync the remote to the car.
a)
Install the remote-control batteries (AA not included).
b)
Hold the frequency button (Large button at top of remote)
2-4 seconds, the Low speed LED light should be flashing.
c)
Turn on the car by pressing the Power button, the Low
speed LED light should still be flashing and then turn to a
steady light. If correct, then sync succeeded.
d)
If the syncing failed (Low speed LED light still flashing),
remove the batteries and repeat steps a
–
b.
e)
Without operation of remote after 10 seconds the remote-
control indication light will go off and into power saving mode.
f)
Button Descriptions:
Forward Backward Turn Right Turn Left
S = Speed
–
Push button for speed selection.
3 speed selections
P = Emergency brake, press it once to stop motion of car.
Pressing it
again will release the emergency brake, restoring the functions of the
car.
