USER MANUAL FOR URC22D
2008-06-08
3
example:
TV1
) for more than
3 seconds
and then release them, the auto search
begins. The remote control enters into Auto Search, LED flashing, and remote
control transmits power signal every 2.0 seconds automatically.
C. See if the device
reacts
or not, once the device reacts, press any key (except SET
key) to stop the auto search.
D. Test if the other keys work good enough. If most keys work not good enough,
please go to step B-D using Auto Search again to find the best code.
Remark: A. whenever you want to leave Auto Search mode, press any key (except SET key) to quit, and the LED
will be off. The search is over.
B. When remote control searches through all different type of codes (about 5 minutes), LED will have been
on for 2 seconds, then the remote control will quit from search process automatically.
C. In case of you do not stop the auto search on time when you find the device reacts, you may use the
M anual Search to search back to find the reactive code.
Device Lock/Unlock
This function will make one device code fixed and can not be changed by code setup
by Manual Search or Auto Search:
A. Strike the device key that you want to fix such as [TV1], [SAT], [AUX], etc
B. Press and hold the [SET] key, then press the [7] key, then release the both pressed
keys, the LED will blink once then off, the code of the current device are locked.
C. If you want unlock the current code, press and hold the [SET] key, Then press the
[8] key, then release the pressed keys, the LED will blink once and then off, the
current code unlocked.
Remark:
A. The fixed code can be changed by unlock or reset only.
B. Only one code can be locked in all devices. If you try to set this function at difference devices, the system
would reserve the last setup only. You can make the operation of unlock under any device.
Volume and Mute Lock/Unlock
This function makes you very convenient when you only use one device to adjust
volume. For example, you may use your amplifier as your main volume control, then
you can use this function to fix the volume and mute key of AUX (amplifier inside
AUX), no matter which device you will use (even you will use TV, VCR etc, the
volume and mute key of remote control still control the volume and mute of your
amplifier).
A. Strike the device key that the volume and mute key you want to fix such as [TV1],
[SAT], [AUX], etc.
B. Press and hold the [SET] key, then press the [5] key, then release the both pressed
keys, the LED will blink once then off, the volume and mute key of the current
device are locked.