Getting Started
5
Features
Part names and features
Name
Feature
RF card touch area
Reads RF cards for entering and exiting.
LED lamp
•
Green: Authentication success
•
Red: Authentication failure
•
Pink: Processing
•
Blue and sky-blue alternate flashing every 2 seconds: Normal operation
•
Red and pink alternate flashing every 2 seconds: The device is locked.
•
Blue and red alternate flashing every 2 seconds: The clock has been reset due to an empty
internal battery. (The clock needs to be reconfigured.)
•
Blue and yellow alternate flashing every 2 seconds: The dynamic IP address has not been
received properly.
•
Red flashes every 2 seconds: Failure to reset. Contact the manufacturer.
•
Yellow flashes every 2 seconds: Waiting for an input.
Fingerprint reader
Reads fingerprints placed on it for entering and exiting.
5-pin cable connector
Connects power and RS-485.
4-pin cable connector
Connects an Ethernet cable.
7-pin cable connector
Connects the switch inputs and relay outputs.
DIP switch
Sets the RS-485 termination resistor and resets the network settings.
•
1
: If the termination resistor of BioEntry Plus is required, set to ON.
•
2
: Resets the network settings to the default. For details, refer to the
Resetting Network Set
ting
.
3-pin cable connector
Selects between Wiegand input and output.
Fingerprint reader
RF card touch area
LED lamp
4-pin cable connector
5-pin cable connector
7-pin cable connector
DIP switch
3-pin cable connector
