2.2.1 Operation of Controller
1.
Startup & shutdown
•
Briefly hold the key to wake up the display.
•
If no keys are pressed for 1 minute the display will turn off.
2.
Switching between modes
•
Under the main interface, press to switch the unit between heating, cooling and
automatic mode.
3.
Temperature setting
•
Press or to enter temperature setting.
•
Press or to increase or decrease target temperature.
•
Press to return and save the setting.
Note: Under the temperature setting interface, if the is pressed, the system will return to the
main interface without any changes saved. If there is no operation for 5 seconds, the system will
automatically memorise user's setting, and return to the main interface.
4.
Setting of timing ON / OFF
•
Hold for 5 seconds.
•
Select parameter using or (see below table).
•
Press to save settings.
•
Repeat for different parameters.
•
Press to return to main interface.
PARAMETER NUMBER
PARAMETER MEANING
PARAMETER RANGE
v03
Set hours ON
0-23
v04
Set minutes ON
10/20/30/40/50
v05
Set hours OFF
0-23
v06
Set minutes OFF
10/20/30/40/50
v07
Timer ON
0- not enabled, 1- enabled
v08
Timer OFF
0- not enabled, 1- enabled
HEATING MODE
COOLING MODE
AUTOMATIC MODE
Heatseeker NovaS Heat Pump
Installation & User Manual
08
Summary of Contents for Heatseeker NovaS
Page 37: ...10 9 Device Management Heatseeker NovaS Heat Pump Installation User Manual 35...
Page 38: ...Heatseeker NovaS Heat Pump Installation User Manual 36...
Page 42: ...NOTES Heatseeker NovaS Heat Pump Installation User Manual 40...
Page 43: ...Heatseeker NovaS Heat Pump Installation User Manual 41...