2.
Anatomy and Usage
2.1
Front Panel
IN
Instrument input for the amplifier.
VOL
Controls the volume level of the amplifier.
TONE
Controls the Bass/Treble balance.
VERB
Controls the volume level of the spring reverb effect.
SPEED
Controls the speed of the tremolo effect.
DEPTH
Controls the depth or the amount of throb in the tremolo effect.
DEPTH
Controls the depth of the Tremolo effect.
WATTAGE SELECTOR
Switches between 6 and 14 watts of output power.
STANDBY SWITCH
This turns on the high voltage to the tubes. The tubes should warm up for at least one minute before
turning standby switch to OPERATE. Be sure that the Volume control is set to a reasonable position
before switching the amp to OPERATE as this amp can be very loud! For short breaks (5 minutes or
less), using the standby switch will increase tube life.
PILOT LIGHT
This shows that AC Mains voltage is flowing to the amplifier.
POWER SWITCH
Turns on AC power to the amp. The Power switch should be turned on, and the pilot light should be
lit for 1 minute before turning the standby switch to OPERATE.
3