4
IN 1+2
Instrument input for using channel 1 and channel 2 in parallel. Plugging an instrument into this input, sends the signal
to both preamps in parallel. When a second instrument is connected to In 2, In 1+2 only connects to channel 1.
IN 2
Instrument input for using channel two by itself.
VOL 1
Controls the volume level of channel 1.
VOL 2
Controls the volume level of channel 2.
TONE
Controls Bass/Treble balance.
SPEED
Controls the speed of the Tremolo effect.
TREMOLO FTSW
Allows remote shutoff of the Tremolo function via latching footswitch, using a 1/4” TS cable.
DEPTH
Controls the depth of the Tremolo effect.
STANDBY SWITCH
This turns on the high voltage to the tubes. The tubes should warm up for at least one minute before turning Standby
switch to ON. Be sure that the Volume control is set to a reasonable position before switching the amplifier ON as this
amplifier can be very loud! For short breaks (5 minutes or less), using the Standby switch will increase tube life.
PILOT LIGHT
This shows that AC Mains voltage is flowing to the amplifier.
POWER SWITCH
Turns on AC power to the amplifier. The Power switch should be turned on, and the pilot light should be lit for 1 minute
before turning the Standby switch to ON.
2. ANATOMY AND USAGE
2.1 FRONT PANEL
