PLEASE TAKE THE TIME TO READ THIS PAPER
BEFORE STARTING YOUR MACHINE
Remove the
Surcare – V4
from its box and stand in an upright position. Check to see that there
has been no damage to the
Surcare – V4
in transit. If there is damage to the
Surcare – V4
,
contact supplier for replacement.
Do not use machine that is damaged in any way.
Roll machine over onto its side
(Figure 1)
. Do not roll machine onto its front or back.
The SMF-
V4 is designed to rest on the side as shown in
Figure 1
Make sure the Accessory Pad is securely attached to backing plate. Apply the required grade grit
to the Accessory Pad.
IMPORTANT
Do not store Surcare – V4 resting on accessory pads
.
Store the Surcare – V4 on its side or remove accessory
pad from machine when not in use or if transporting.
Figure 1
Do not use Surcare – V4 without vacuum.
The
Surcare – V4
is fitted with a very effective dust
extraction design which also assists in keeping the work surface cool. However, the vacuum
machine used must also be efficient. Vacuum system attachment for dust extraction should
preferably be 1000 watts or more.
Starting the
Surcare – V4
is shown here in
(Figure 2)
- holding the
Surcare – V4
securely with
both hands, release the lock on the-start/stop switch button (turning switch as directed by arrows
located on the switch), positioned on the side of control box. When machine has started the left
hand can then hold the vacuum hose and power cord
(Figure 3)
.
One hand should be positioned on side handle or Quick Release Handle; (the vacuum hose and
power cord can be cable tied to extension handle or held away from the work surface) whilst the
other hand is free to hold edge of fan cowl or turn machine off when work is completed
(Figure 3)
.
The
Surcare –
V4
can then be gently guided across the work surface.
Figure 2
Figure 3
