Operating Instructions
1.
Plug into 120V electrical outlet.
2.
Insert 0.43 diameter full size glue stick into back of glue gun (feeder tube).
3.
Allow gun to heat for 5 minutes.
4.
Squeeze trigger to dispense glue. More glue is dispensed by squeezing the trigger again.
Continue glue flow by adding additional glue sticks. Note: Requires approximately 2 glue
sticks for initial startup.
5.
Press surfaces to be glued together immediately.
6.
Do not pull glue sticks form glue gun. If changing glue, feed remainder of glue stick
through the glue gun.
7.
Unplug after use and allow to cool before storing.
Troubleshooting
The glue gun will not heat up:
Make sure the glue gun is plugged into a 120V electrical outlet.
If the glue gun still does not work, the internal fuse of the glue gun may be blown, and the glue
gun is not repairable. DO NOT USE.
Glue backs up at inlet tube:
Glue sticks may be the wrong size. Use only the recommended
0.43
Note
: DO NOT elevate the front of the glue gun. Always use side fins
or attached stand.
CAUTION:
DO NOT touch glue gun nozzle or melted glue; temperature can reach 380° F. If
accidental contact occurs, do not remove glue. Immediately put burned area into cold water.
Always wear protective clothing safety glasses, gloves, long sleeve t-shirt and pants. Keep
away from flammable materials. Manufacturer assumes no responsibility for consequential or
indirect damages from the use of this product.
