SureCall, Inc | 1-888-365-6283 | support@surecall.com | www.surecall.com
SureCall, Inc | 1-888-365-6283 | support@surecall.com | www.surecall.com
8
Mount antenna to a vertical surface:
1. Using vertical plate of bracket, mark position of desired placement. The omni
antenna should be mounted in an upright position (See “Omni Antenna Install
Illustration”)
2. Unscrew nut from end of stucco screw and remove it along with lock washer and
regular washer.
3. Place vertical plate into desired location and tap the screws, head first, along with
sleeve, into stucco 1/2 to 5/8 inches deep into place.
4. In this order, place washer, lock washer and nut on each screw and tighten until
secure. When tightening screw, sleeve will expand to secure plate.
5. Use provided screws to secure antenna base onto horizontal plate.
6. Connect antenna to one end of the provided RG6 cable and tighten the
connection. Run the cable along route to planned location of your booster.
Note: Alternate screws may be required for differing surfaces such as wood or concrete.
Nuts &
Washers
L-Bracket
Cable
Anchors /
Sleeves
Screws
Omni Antenna Install Illustration
Installation
Option B:
Yagi Antenna
Option A:
Omni Antenna
Pole-mount hardware
Omni antenna with
surface mount hardware