12
Installing Your Hardware
Installing Panel Antenna(s)
The provided panel antennas are multi-band directional antennas with a 120˚ reach. They should be mounted
facing the area signal is needed. It is also important that they do not point toward the outdoor antenna.
Besides the antenna itself, parts include mounting equipment for a flat horizontal surface. You can also install your
interior antenna behind a wall or above a ceiling panel provided there are not materials that could obstruct signals.
For Each Indoor Panel Antenna:
1. Choose location for mounting antenna on vertical surface. Ideal height off the ground or floor should be the
approximate height of regular cell phone use.
2. Using plate, mark position of desired screw placement with pencil or marker.
3. Screw mounting plate into place with the slide panel protruding towards you.
4. Slide antenna securely onto mounting plate.
5.
Connect antenna to an indoor cable (1 per antenna) of and run along route to planned location of your
booster’s cable splitter.
6.
Once all indoor antennas and cables are in place, connect cable runs from indoor antennas to the splitter
Outdoor
Cable
Indoor Panel
Indoor Panel
Splitter
Indoor
Cables
Indoor
Cable
Planned
booster
location
RF CABLE
SC-400
FLAT SURFACE
MOUNTING PLATE
SCREWS
SureCall | 48346 Milmont Drive, Fremont CA 94538 | 1-888-365-6283 | support@surecall.com