LIGHT ACTIVATION
High Output: Pressing either pushbutton switch once will activate the high output. Pressing
either switch individually again after 0.5 seconds will turn the light off.
Medium Output: Pressing either pushbutton switch twice within 0.5 seconds will activate the
high output and then the medium output. To turn the light off, press either switch again.
Low Output: Pressing either pushbutton switch three times within 0.5 seconds will activate
the high output, medium output and then the low output. To turn the light off, press
either switch again.
When using the WristLight with a handgun, When using the WristLight with a handgun,
activate light—strapped to your support (non-gun) wrist—before drawing pistol from
holster. Deactivate light after safely holstering pistol. Do not activate, deactivate, or adjust
your 2211 Signature while holding a firearm.
PROGRAMMING THE 2211 SIGNATURE’S ACTIVATION SEQUENCE
The 2211 SIGNATURE’S default activation sequence goes from high to medium to low output and then
off; however, it can also be programmed by the user to reverse this sequence—low-med-high-off—to
accommodate personal preference. The 2211 Signature must be plugged into its charger to program the
activation sequence. Once programmed and removed from its charger, the activation sequence will not
change unless the 2211 Signature is reprogrammed to its default sequence.
To reverse the 2211 Signature’s default activation sequence:
1. Plug 2211 Signature into its charger
2. Press and release one of the pushbuttons three times until low output is activated
3. Wait 5 or more seconds, then press one of the pushbuttons once more, turning the 2211 Signature off
4. Remove 2211 Signature from its charger and test activation sequence — it should now be low-med-high-off
3
