4
1. Use with the nozzles pointed down and forward
(pivot coupler in back position) to wash large flat
surfaces like sidewalks or driveways. Walk slowly
behind the cleaner, cleaning as you go.
2. Rotate the spray bar 180° so the nozzles are
pointed upward (make sure the pivot coupler is in
the forward position) to clean the underside of
raised items like your car’s undercarriage.
To reduce the risk of injection or injury, never lift the
cleaner while operating the pressure washer.
WARNING:
To reduce the risk of injection or injury, do not depress
the trigger until the cleaner nozzles are completely
underneath the surface being cleaned, and always
release the trigger before removing the cleaner from
underneath the surface.
WARNING:
OPERATING INSTRUCTIONS
MAINTENANCE
1
1
2
www.surfacemaxx.com
Inlet plug filter
A clogged or dirty nozzle will result in excessive pump
pressure causing a pulsing sensation.
1. Turn off the pressure washer and turn off the water
supply. Release the residual pressure by
squeezing the gun’s trigger.
2. Disconnect the pressure washer wand from the
cleaner.
3. Remove the inlet plug filter and clean with running
water. (See Figure 1)
