3. The Create Replication window will be displayed. Set the options below and click “OK” when
done.
Replication Options:
[Remote]
♦
Local
- Select the IP address of the local (source) proNAS that will be used for replication.
♦
Remote
- Select or type manually the IP address of remote (destination) proNAS that will be used
for replication.
NOTE: The local and remote IP addresses serve as the channel between the
source and destination NAS servers. This is where the replication of data takes
place. Please be sure to have a good connection on this medium. As much as
possible, set this channel as a dedicated or a private network. It is
recommended to use different Ethernet port for replication from the Ethernet
port used for data access. It is best to use a crossover network link between
the Ethernet ports involved. Refer to Network Manager Section for configuring
Ethernet port.
♦
Remote VG
- Select the VG on remote proNAS where the replicated logical volume will be
created.
Summary of Contents for TRITON 16Ni
