3.4 Connecting SAS JBOD Disk Drive Enclosures
1. To connect 1
st
JBOD enclosure, using the supplied 1m external SAS cable. Insert one end to
the SAS Expansion Port of the main chassis, and insert the other end to the SAS In port of
the JBOD enclosure (JBOD#1).
2. If there are additional JBOD enclosures to be connected, connect other 1m external SAS
cable from the SAS Expansion Port of JBOD #1 to the SAS In Port of the next JBOD
enclosure (JBOD #2). Repeat the process until the last JBOD chassis is connected in a daisy-
chain configuration, see next figure.
Summary of Contents for TRITON 16Ni
