iControl Manual
10
state prior to the shutdown event; “Last Known State” will return the outlet to its state prior to
the shutdown event.
ICE
sets the enabling or disabling of the ICE function. This is available only for outlets 1 and 2.
Security
This page is used to set passwords for each of the three access levels: Viewer, User, and Admin.
Press “Save” to save your selections.
*Defaults are Viewer/viewer, User/user, Admin/admin.
Front Panel Reset Button
The reset button is located towards the left side of the front panel, and is accessible by a small
item such as a paperclip. The reset button performs 2 functions: System Reboot and System
Restore to Factory Defaults.
System Reboot
To reboot the iControl firmware, press and hold the front panel reset button until the LEDs turn
off (approximately 1 second), then release. The system will then reboot.
System Restore to Factory Defaults
*Warning: removes all configuration information, including network setup, email setup, outlets
setup, sequences, and schedules.
Method 1
To restore the iControl firmware to its factory default state, press and hold the front panel reset
button until the LEDs turn off (approximately 1 second), continue holding until the LEDs all turn
on again (approximately 4 seconds after they turn off), then release. The system will reboot with
factory default settings restored.
Method 2
If Method 1 does not work, or if the iControl firmware appears to be “stuck” or “hung”, try
Method 2 for restoring the factory default settings. Disconnect the iControl hardware from the ac
power source. While pressing and holding the front panel reset button, connect the hardware to
the ac power source. Wait until the LEDs all turn on and then off, then release the reset button.
The system will reboot with factory default settings restored.