XU115 Manual
7
XU115-510
SPECIFICATIONS
AC Input
Number of Phases:
Single (2W + G)
Power Cord:
6-ft. grounded, 3 wire, #14 line cord
Input Voltage (Acceptable Input Voltage):
120VAC (0 - 160VAC)
Input Voltage Range (Normal mode):
90 - 150VAC
DC Start Capability:
Yes, (defaults to 60Hz)
Power Requirements (no load):
35 watts (charging), 15 watts (charged)
AC Output (Normal Mode)
Load Rating:
15 Amps @ 120 volts
Load Power Factor:
0.6
Outlets:
6 outlets (15 Amp) all with Advanced Series Mode surge elimination, 4 outlets with battery back-up
Output Frequency:
Same as Input
Short Circuit Protection:
Re-settable circuit breaker and electronically limited
Overload Capability:
110% - 5 minutes
≥120%
- immediate shutdown
Output Voltage Regulation:
120VAC: -12.5% to +8.4%
Waveform:
Same as Input
Boost Mode Voltage (Buck mode voltage):
N16% (Nominal -14%)
Line Mode Voltage Range:
105 - 130VAC
Efficiency:
Normal mode > 90%
AC Output (Battery Mode)
Capacity:
1000VA/600W
Back-up Run Time:
4 minutes 600W full load, 10.4 minutes 300W half load
Output voltage:
Nominal 120VAC
Waveform:
Stepped sine wave (simulated sine wave)
Topology:
Single boost/buck line interactive, simulated sine wave
Battery Mode Voltage Regulation:
Nominal ± 6% until LBW
Transfer Time:
6-10 ms
Output Frequency & Regulation:
50/60Hz ± 0.5Hz (Unless synchronized to utility)
Short Circuit Protection:
Active electronic (current limit)
Batteries
Battery Rating:
(2) 12V/7AH
Replacement:
Hot swappable
Recharge Time:
8 hours to 90% after full load discharge
