Operation
12
5. Push the hot-melt adhesive candle to the opening in the rear of the
device.
6. Insert a new glue stick when the red LED glue stick slot (8) lights up.
3.3
Setting the stroke limit
The left side of the supporting foot has a switch (4) for adjusting the hot melt
adhesive delivery rate.
• Switch setting „+“ for continuous glueing with maximum throughput of hot
melt adhesive.
• Switch setting „-“ for small areas, particularly precise glueing with low
throughput of hot melt adhesive.
Fig. 1:
Switch
3.4
Operating information
Please observe the supplied Döllken instructions for hot-melt adhesive to
ensure perfect adhesive application.
• Surfaces to be glued should be be acclimatized to at least 18 °C and free
of dust, grease and moisture. Remainders of wax, separating oils, plasticiz-
ers or impregnation media on the workpieces can lead to loosening of the
adhesion immediately or later.
• For optimum glueing, the adhesive must be applied evenly, continuously
and in sufficient quantity.
• Never extract the old adhesive candle from the device. Protruding sticks
must be cut off and reused later.
3.5
Breaks/end of work
Turn the device off at the power switch (6) if you do not require any adhesive
for longer than 20 minutes.
The adhesive can remain in the device and be remelted later on.
GB
H1079XM_191202.indd 12
18.12.19 09:11
Summary of Contents for Dollken Profiles HKP 2.0 E
Page 33: ...33 1 1 1 1 200 C Xi 1 2 1 2 D llken RUS H1079XM_191202 indd 33 18 12 19 09 11...
Page 34: ...34 5 2 HKP 2 0 E 1 1 2 2 1 HKP 2 0 E D llken RUS H1079XM_191202 indd 34 18 12 19 09 11...
Page 37: ...37 Bild 2 3 4 D llken 18 C 3 5 6 20 3 6 1 2 3 1 RUS H1079XM_191202 indd 37 18 12 19 09 11...
Page 38: ...38 4 4 4 5 6 RUS H1079XM_191202 indd 38 18 12 19 09 11...
