LIGHT MODES
To turn on the headlamp push the button 1, the headlamps have 5 light modes:
1º Click Flashlight
2º. Click Floodlight
3º Click Combinated light
4º Click Emergency red light
5º Click Red S.O.S.
LIGHT MODE WITH SENSOR
To activate the sensor mode:
First select the light that you need pushing the button 1, once
you select the mode push the button 2 and blue light turn on
this indicate that the mode is active.
Pass a hand front the headlamp, the light turn on and off when
this detect moves.
WARNING!: Read, understand and
follow the safety rules in this
document before operating this
product.
This product has a 1 year warranty by Urrea Herramientas Profesionales S.A. de C.V. against any manufacturing defect. The warranty is not applicable if the product does not show the URREA brand, if the product is worn out by its
daily use, shows signs of abuse, damage, its original composition has been altered, or specifies a different warranty. In order to make the warranty effective, the product must be taken to the company or to the place of purchase
along with its receipt.
IMPORTED BY: URREA HERRAMIENTAS PROFESIONALES S.A. DE C.V. km 11,5 Carretera a El Castillo, C.P. 45680 El Salto, Jalisco, México Tel. 01 (33) 3208-7900 Made in China / Hecho en China R.F.C. UHP900402Q29
04 G18
WARNING!:
Read, understand and follow the safety rules in this document before operating this product.
RECHARGING THE BATTERY
LIGHT MODE SEQUENCE
1
2
CARE AND MAINTENANCE
OPERATION
IMPORTANT! Battery is ready to use when purchased, do not recharge before first use.
A fully charged battery will provide approximately 3 hours of continuous light. Do not allow the
battery to completely discharge.
IMPORTANT! Unlock and turn the spotlight OFF before charging from an AC or DC outlet.
Leaving the spotlight ON during charging may cause damage to the battery and AC charger.
CONTENT
USB Rechargeable headlamp.
USB cord.
1
1
SAFETY INFORMATION
Never place the spotlight face down when
light is on or is still hot from recent use.
Doing so could burn/ignite surfaces such
as seats, carpeting, etc. and cause major
property damage. Always turn the spotlight
off when not in use.
Always unplug the charger from the and
power source when not in use.
To prevent serious damage to eyesight,
never look into the light when the is on.
DO NOT shine light into the face of
someone else.
DO NOT touch the lens of the spotlight
when light is on or if it was recently on.
The lens will be hot and could cause
serious burns.
DO NOT place the spotlight in water.
1
2
3
4
5
Keep all components dry and out of
water at all times. Dry location use only.
DO NOT use this product for other than
its intended use.
DO NOT charge or operate in close
proximity of combustible or flammable
materials.
DO NOT charge battery in gas tight
enclosures.
DO NOT use an outdoor AC outlet to
recharge battery.
To prevent accidental electrical shock we
recommend this product always be
charged on a GFCI (Ground Fault Circuit
Interrupter) outlet.
DO NOT disassemble or tamper with
the battery.
DO NOT dispose of battery in fire as this
may result in explosion.
DO NOT use the spotlight while it is charging
6
7
8
9
10
11
12
13
1
2
3
Insert the micro-USB end of the cord into the charging port on the bottom of the headlamp.
Insert the normal USB into a power source to start charging. Charging is indicated by a RED LED.
Charging is finished when the charging LED indicator light turns GREEN. Disconnect the cord.
135911
RECHARGING THE BATTERY
Light Source:
COB LED (3 W)
Voltage:
3,7 V
Battery:
Litio 3,7 V 1200 mAh
Luminous Flux:
250 Lumens
Color Temperature:
6500K
Beam distance:
30 m
TECHNICAL SPECIFICATIONS
250 lm Headlamp Rechargeable
Linterna para Cabeza Recargable 250 lm
USB charging port
Principal
LED
Sensor
Receiver
3W COB
LED
Button 1
Button 2
45º inclination
Sensor
Sensor
Do not leave that the battery totally discharge.
To get a better battery performance, don't disconect the product of the charger until the battery
be full.
