15
• Bearing of the infeed and output roller
• Bearing of pulley and sprocket
The threaded spindle for height-adjustment of
the jointer table may only be treated with a
dry lubricant agent.
• The table surfaces as well as the infeed and
output rollers must always be kept free from
resin.
• Regularly clean infeed and output rollers.
• In order to avoid overheating of the motor,
regularly check the air openings for any dust
sticking on.
• After a longer period of use, it is recom-
mended to have the machine checked by an
authorized dealer service.
Tool care
Cutter block, clamping devices, knife supports
and knives must be regularly cleaned from res-
in, as a clean tool improves the planing quality.
To this purpose, clamping devices, knife sup-
ports and knives can be put in a common resin
remover for 24 hours.
Resin from aluminum tools may only be re-
moved with cleaning liquids not being aggres-
sive to this type of metal.
TROUBLESHOOTING
MACHINE CANNOT BE SWITCHED ON
No power supply. Check power supply.
Carbon brush worn. Take machine to your ser-
vice point.
MACHINE SWITCHES AUTOMATICALLY OFF
DURING IDLE RUN
No mains supply. Check fuses. Due to the in-
tegrated low-voltage protection, the machine
does not restart automatically. Upon return of
the voltage, the machine must be switched on
again.
MACHINE STOPS DURING PLANING
Overload protection reacts due to blunt kni-
ves, infeed too fast, or chip removal too thick.
Before work is continued, replace knives or let
cool down the motor.
PLANED SURFACE NOT SMOOTH
Infeed too fast. Reduce infeed speed.
Blunt knives. Replace knives.
Irregular feed. Apply constand pressure and re-
duce feed.
WHEN JOINTING, CHIP EJECTION OBSTRUCTED
(without dust extractor)
Chip removal too important. Chip removal too
important.
Blunt knives. Replace knives.
Wood too humid.
WITH SURFACE PLANING AND THICKNESSING,
CHIP EJECTION OBSTRUCTED (with dust extrac-
tor)
Chip removal too important. Chip removal too
important.
Blunt knives. Replace knives.
Wood too humid.
WITH SURFACE PLANING AND THICKNESSING,
CHIP EJECTION OBSTRUCTED (with dust extrac-
tor)
Suction performance too weak. Use a dust ex-
tractor unit having an air-flow rate at the suc-
tion connection of at least 20 m/s.
RPM DROPS DURING PLANING
Chip removal too important.
TECHNICAL DATA
VOLTAGE-FREQUENCY
CUTTING WIDTH PLANER
MODE
CUTTING WIDTH JOINTER
MODE
SPEED
CUTTING CAPACITY
hard wood;
soft wood;
POWER
POWER CONSUMPTION
WEIGHT
110 V ~ 60 Hz
6" (152 mm)
6" (152 mm)
8 500 r/min
1,1 mm
1,5 mm
1 100 W
0,64 kWh
21 kg (46,2 lb)
E N G L I S H •
User's manual
CN506 manual.indd 15
23/06/15 17:07
