Standard Operating Procedures
L410 UVP-E20
Document No.:
SOP-L410-1
Page 7- 16
Rev: 1
Date: JAN 18
Prepared by: LA
Checked by : CLS
At DA/H
PF:
“minimum”
PM
: “NOT VISUAL” or landing
reference”
Eg. “lights straight-ahead”
Call by
PF
at minima, PM shall
state if visual reference has
been acquired or not.
If visual
PF:
“LANDING, AP-YD
DISCONNECT”
PM:
“CHECK, AP-YD
DISCONNECTED”
Call made by
PF.
PF
manually disconnect the
autopilot.
PM
check autopilot
disconnected.
OR
If not visual
PF:
“GO AROUND”
PF
make decision at minimum
If No response by the PF
PM:
“GO AROUND”
PM
calls action required
PF Commences the missed approach
and calls
PF:
“GOING AROUND,SETPOWER,
FLAPS 18”
PM:
“POWER SET, FLAPS 18”
PF
calls for go around power.
PM
sets power and flaps as
required for the go around
procedure.
Set the flap and check instruments for
positive climb rate
PM: “
POSITIVE RATE”
PF:
“GEAR UP”
PM: “
GEAR UP SELECTED, GEAR
UP, lights out”
Call made by
PM
,
PFcrosschecks positive rate of
climb and call for gear up.
7.17.2 AP/ FD Use on ILS Approaches
When on an intercept heading and cleared for the approach, select APR andobserve the LOC
and GS annunciations.
APR mode should not be selected until:
•
The ILS is tuned and identified
•
The aircraft is on an inbound intercept heading
•
Both localizer and glide slope pointers appear on the PFD display in theproper position
(correct sense)
•
Clearance for the approach has been received.
Summary of Contents for L410 UVP-E20
Page 5: ......