Standard Operating Procedures
L410 UVP-E20
Document No.:
SOP-L410-1
Page 7- 25
Rev: 1
Date: JAN 18
Prepared by: LA
Checked by : CLS
7.20 Missed Approach
Once reaching minimum, the PF calls “ minimum and state the action: Landing/Go around,
however if the PF doesn’t make the call out, the PM must immediately call out: minimum and if
not visual, PM must call “Go Around”.
If there is no response from the PF when the PM calls “Go Around”, the PM shall assume pilot
incapacitation, call put: “I have controls” and commence a go around.
The Captain may elect to call for the go around prior to reaching the decision altitude/MAP if
the quality of the approach is below the required standards.
7.20.1 Missed Approach Callout Table
If not visual
PF:
“GO AROUND”
PF
make decision at minimum
If No response by the PF
PM:
“GO AROUND”
PM
calls action required
PF Commences the missed approach
and calls
PF:
“GOING AROUND,SETPOWER,
FLAPS 18”
PM:
“POWER SET, FLAPS 18”
PF
calls for go around power.
PM
sets power and flaps as
required for the go around
procedure.
Set the flap and check instruments for
positive climb rate
PM: “
POSITIVE RATE”
PF:
“GEAR UP”
PM: “
GEAR UP SELECTED, GEAR
UP, lights out”
Call made by
PM
,
PFcrosschecks positive rate of
climb and call for gear up.
Summary of Contents for L410 UVP-E20
Page 5: ......
