Sutron Corporation X-Link Operations & Maintenance Manual, Rev 1.63 5/24/2016 pg. 130
Prior to version 1.46, X-Link would not allow the customer to remotely turn off
Recording or Tx Enable.
14.4.
Status
To check the status, type STATUS (or just S).
>STATUS
X-Link: X-Link ver 1.04
Station Name = SUTRON DEV1
System In Alarm
Measurement M1 STAGE reading
10.16
2012/03/30 12:10:15
Into Alarm
Recording = On
4 Meas Active
GPRS Modem: Off.
Tx Enable = On, Tx Mode = Internet Only, Listening =
On
Tx today: good 2, bad 0
Last Scheduled Tx, Completed, Success, 2012/03/30
12:00:10
Last Alarm Tx, Completed, Success, 2012/03/30
11:56:20
Next Scheduled Tx, Future, 2012/03/30 16:00:10
Next Alarm Tx, In progress, 2012/03/30 12:10:15
System Time 2012/03/30 12:10:19
Recording since
2012/03/30 12:10:10
Booted at
2012/03/30 11:55:33
Battery 14.0V
14.5.
Setup
To view the whole measurement setup, type SETUP. To view just the setup of
measurement one, type M1. Likewise, M2 shows the setup of the second
measurement. Only pertinent data is shown. If a measurement is not active, it
will not show its setup fields. If a measurement is of type analog, it will not show
its SDI-12 setup fields.