Sutron Corporation X-Link Operations & Maintenance Manual, Rev 1.63 5/24/2016 pg. 17
6.
Select the Measurements tab. This is where you will set up X-Link to
measure, process, and log data. If the unit is in its factory default condition,
there will be no measurements enabled. To set up measurements, see page
68.
We recommend that you setup and test all measurements before deploying
the station in the field.
7.
Select the Telemetry tab. This is where you will set up X-Link to transmit the
data. If the unit is in its factory default condition, there will be no telemetry
enabled. To set up telemetry, see page 92.
We recommend that you setup and test the telemetry setup before deploying
the station in the field.
8.
Select the Diagnostics tab. This is where you set the unit to factory defaults
or to use the terminal tool. To set up diagnostics, see page 41.
9.
To access the main menu, press the
button in the upper left. Use options
on the main menu to send/get setups, start/stop recording, exit the
application, etc.